My storyboard was one image with six panels. In the fourth panel, a record shop clerk holds a cardboard lid halfway open. I wanted to see how that…
My storyboard was one image with six panels. In the fourth panel, a record shop clerk holds a cardboard lid halfway open. I wanted to see how that lid would close before spending time animating the rest of the sequence. Split the storyboard into six images I connected the storyboard image to the Tool node in Astorie Canvas, switched to Grid Crop, and set it to 3 columns and 2 rows. The tool showed six tiles.
I checked the order from left to right, starting with the top row, then selected all six and clicked Create. Each tile became its own Image node, ready to connect to a Video node. The original storyboard on the left, the grid crop in the middle, and six individual shots on the right. Pick one action to test I’d start with panel four.
The clerk already has her hands on the lid, and part of the red circle on the record sleeve is still visible inside the box. That gives the video a clear starting position and one action to finish. Connect that Image node to a Video node in Image to Video mode and use the panel as the starting frame. Here’s the motion prompt I’d use: The clerk lowers the cardboard lid until it rests flat against the box.
Her hands guide it down, then settle on top. The box stays in place on the counter. Hold the camera steady. End with the box closed and unsealed. When the clip comes back, I’d watch the hinge and the clerk’s hands. The lid should rotate down, gradually hide the record sleeve, and come to rest flat. The tape belongs in the next shot, so this clip ends as soon as the box closes. That’s the handoff I wanted from the storyboard.
Each panel is ready to use on its own, and I can check a single action in motion before generating the rest.
This is a source-linked briefing. Read the original report from Dev Community .